How to use profiles in DNC

[Charlie]

In the first picture below the first thing you have to do to set a profile up is click on the top box drop down and select new now type in your name mine was micro1.
Now select your laungages and subtitles you would like.
Target size is set for dvd5 you can also change this in the drop down box for dual layer or custom mode .
In the first picture I selected sharp fast not recommended default reads are.
the next box down I selected. Activate software compatiblity mode this is only selected if your are using ANYDVD for your decrypter.
In the next box I checked enable preview now select the box okay and you have now created your first profile.
I created 3 profile modes picture 1 for dvd5 mode or single layer media.
Picture 2 set up another profile for dual layer media.
Picture three I setup for custom size for my single layer media.
Now I have three profiles and the rest is simple as the pictures will explain!!


profile 1 dvd-5

http://i165.photobucket.com/albums/u50/kelchichi/1-1.jpg


Profile 2 Dual layer


http://i165.photobucket.com/albums/u50/kelchichi/2.jpg


Profile 3 custom

http://i165.photobucket.com/albums/u50/kelchichi/3.jpg

profile 1 micro1 dvd-5

http://i165.photobucket.com/albums/u50/kelchichi/11.jpg

profile 2 Micro2 dual layered

http://i165.photobucket.com/albums/u50/kelchichi/22.jpg

Profile 3 Micro3 custom mode

http://i165.photobucket.com/albums/u50/kelchichi/33.jpg


the rest is very easy select the profile box and select the profile you wish to use and then either save as an iso to the projects library by checking that box or burn after convert or auto burn after convert then copy movie only or full disc.
Its that easy and you can setup as many profiles as you wish too!!